I have installed madExcept 5.0.0 to use with Delphi 10.3.3 (community edition)
my choice at the install process was to select :
at the end of installation a pop-up window information display :
'madBasic' installed successfully.
'madDisAsm' installed successfully.
'madExcept' installed successfully.
'madKernel' installed successfully.
'madSecurity' installed successfully.
'madShell' installed successfully.
I added in uses clause of myproject.dpr :
When i compile myproject I receive the message :
[madExcept Avertissement] Mapping binary file failed (2)
and MadExcept will not fire on error (in my case i do a zero div)
on the same desktop I have Delphi XE5 and in this case MadExcept works well.
I leave the process install of MadExcept without any interferences,
so MadExcept was installed in C:\Program Files (x86)\madCollection
After that :
I uninstall MadExcept,
I delete the madCollection directory, where MadExcept where installed,
I deactivate BitDefender for the time of installation
Also I deactivate my Ethernet Card
I redo the install process and : Same cause, same effect.....
Delpi XE5 works well, not Delphi Rad Studio Rio 10.3.3
to check, I use the following code :
Code: Select all
procedure TForm1.plouf1Click(Sender: TObject); var i, j : integer; begin j := 0; i := 17 div j; // oops a zero div ...... end;
and my Ethernet connection )
Thanks if you can help me