[BCB5] [madExcept] unit "madExcept" not found in b
[BCB5] [madExcept] unit "madExcept" not found in b
I've got the checkboxes "handle exception" and "append map.." in the settings dialog set.
The obj files are linked like this
#pragma link "madExcept"
#pragma link "madLinkDisAsm"
The directory of obj files are defined.
The program compiles, but when the dialog box saying "Make: done appears" and I press ok, I get
[madExcept] unit "madExcept" not found in binary file
Any ideas as to why this happens?
Best regards,
Allan
The obj files are linked like this
#pragma link "madExcept"
#pragma link "madLinkDisAsm"
The directory of obj files are defined.
The program compiles, but when the dialog box saying "Make: done appears" and I press ok, I get
[madExcept] unit "madExcept" not found in binary file
Any ideas as to why this happens?
Best regards,
Allan
So that means that madExcept is either not linked into your exe, or the map file / debug info is incomplete.
Well, I've no idea what to say now. I'm not really such a big BCB expert. Why would BCB refuse to link madExcept in, if we explicitly tell it to?
Perhaps you can try to remove the line:
#pragma link "madExcept"
Does the exe get smaller afterwards?
Well, I've no idea what to say now. I'm not really such a big BCB expert. Why would BCB refuse to link madExcept in, if we explicitly tell it to?
Perhaps you can try to remove the line:
#pragma link "madExcept"
Does the exe get smaller afterwards?