MadExcept prevents D2010 RemoteDebugger loading symbols

gerhardsachs · Post by **gerhardsachs** » Tue Jun 29, 2010 3:46 pm

Hello,

I had continuous trouble running the D2010 remote debugger.
The application could be started on the remote PC from the IDE.
But I could neither set breakpoints nor watch variables.

Today I had a session with Olaf Monien which solved the problem.
It turned out that the debugger worked when MadExcept was disabled.

Are there any settings that allows to have both tools working at the same time ?

Regards
Gerhard Sachs

Post by **madshi** » Wed Jun 30, 2010 1:01 pm

To be honest, I've never used the remote debugger yet. I'll add this to my to do list. Do you need this urgently? My to do list is rather long, I'm afraid...

gerhardsachs · Post by **gerhardsachs** » Wed Jun 30, 2010 1:52 pm

No, it is not very urgent,
most crashes occur on my workstation as well as the target system which means I can use MadExcept.
In the rare cases where I really need the remote debugger, I have a solution.

Regards
gerhard Sachs